User's Manual

Procedure
1. From the System Manager console, select the B5800 Branch Gateway device and
click Edit to edit the system configuration for the device. IP Office Manager will be
launched on your PC. For more information, see Editing a B5800 Branch Gateway
system configuration from System Manager on page 12.
2. In the left navigation pane, click Hunt Group
3. Select the hunt group for which you want to create a mailbox.
4. Click the Voicemail tab.
5. Change the fields as appropriate. See
Voicemail tab field descriptions on page 36
for more information.
6. Click OK to save the changes.
7. Repeat steps 3 through 6 for each hunt group as appropriate.
8. Select File > Save Configuration to merge the changes back to the system.
Voicemail tab field descriptions
Name
Description
Voicemail Code Default = Blank, Range = 0 (no code) to 15 digits. This
field can be used to set a mailbox access code. That
code must then be entered by anyone attempting to
retrieve messages from the mailbox. If remote access is
attempted to a mailbox that has no voicemail code set,
the prompt, "Remote access is not configured on this
mailbox" is played.
The mailbox user can change the code by dialing *04
after having entered the mailbox.
Some rules apply to the voicemail code when the
minimum password length is set to a value other than
none. The voicemail code cannot be:
• the same as the extension number
• the same as the previous one
• consecutive digits
• a single repeated digit
• a code with fewer digits than the minimum password
length
Voicemail On Default = On. When on, calls to the hunt group's number
will divert to voicemail if all available group members are
Hunt group mailbox configuration
36 Implementing Standalone Voice Mail for the Avaya B5800 Branch Gateway June 2012
Comments? [e-mail]