User's Manual

The difference between the two values needs to be greater than or equal to the
desired number of simultaneous SIP trunk connections.
Configuring trunk-to-trunk transfer
Use this procedure to configure Communication Manager to allow trunk-to-trunk transfers.
1. Enter the change system-parameters features command.
2. In the Trunk-to-Trunk Transfer field, enter the appropriate number.
Note:
If the Trunk-to-Trunk Transfer field is set to all, this will enable all trunk-to-trunk
transfers on a system-wide basis.
Note that this feature poses significant security risk, and must be used with
caution. As an alternative, the trunk-to-trunk feature can be implemented using
Class Of Restriction or Class Of Service levels.
Configuring IP node names
Use this procedure to add Avaya Aura
®
Session Manager as an IP node.
1. Enter the change node-names ip command.
2. In the Name field, enter a name for this IP node.
3. In the IP Address field, enter the IP address of the Avaya Aura
®
Session Manager's
Security Module (SM-100) interface.
Configuring IP codec set
If necessary, configure an IP codec set for use with SIP calls.
1. Enter the change ip-codec-set n command, where n is the codec set number to
be used.
2. In the Audio Codec field, enter the desired audio codec type.
3. Retain the default values for the remaining fields.
Configuring trunk-to-trunk transfer
Implementing the Avaya B5800 Branch Gateway November 2011 315