User's Manual

Chapter 15: Safety and regulatory
information
Safety statements
The B5800 Branch Gateway modules are intended to be installed by Service Personnel and
it is the responsibility of the Service Personnel to ensure that all subsidiary interconnected
equipment is wired correctly and also meet the safety requirements of IEC60950 or UL60950
where applicable.
•
The CE mark affixed to this equipment means that the module complies with the 1999/5/
EC (R&TTE), 89/336/EEC (EMC) and 72/23EEC (LVD) Directives.
• The Declarations of Conformity (DoC) for the B5800 Branch Gateway products are
available on the B5800 Branch Gateway Application DVD.
•
Warning:
This warning symbol is found on the base of B5800 Branch Gateway modules.
• Refer to Trunk Interface Modules on page 277 for information concerning which trunk
interface module variants are fitted in which country.
In Finland, Norway and Sweden a protective earthing conductor must be attached to the
protective earth point on the rear of the servers. See Grounding on page 65 for more
information. In addition, the server must be located in a restricted access location where
equipotential bonding has been applied, for example, in a telecommunication center.
Important safety instructions when using your telephone
equipment
When using your telephone equipment, basic safety precautions should always be followed to
reduce the risk of fire, electric shock and injury to persons, including the following:
• Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink
or laundry tub, in a wet basement or near a swimming pool.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a remote risk of electric shock from lightning.
Implementing the Avaya B5800 Branch Gateway November 2011 275