User's Manual

4. Edit the WAN port.
Do not create a new WAN port. The WAN port is automatically detected. If a WAN
port is not displayed, connect the WAN cable, reboot the control unit and receive
the configuration. The WAN port configuration form should now be added.
5. Create an IP Route.
In the IP address field enter the network address of the remote end — not the IP
address of the control unit. Under Destination select the service created above.
6. At Site B, on IP address 192.168.43, repeat steps 1 through 5 but alter the details
to create a route from Site B to Site A.
Additional installation and system procedures
252 Implementing the Avaya B5800 Branch Gateway November 2011
Comments? [e-mail]