User's Manual

To route an incoming video call on the PRI lines configured above to an So8 module requires
the following:
Procedure
1. Create a dial short code that has the SO port as its destination line group. For this
example the following is used:
• Short Code: 1500
• Number:
• Feature: Dial
• Line Group: 601 (the So8 port number)
2. Create an incoming call routing that routes the appropriate calls to that short code.
For this example the following is used:
• Line Group: 95 (identifies calls using the PRI lines configured above)
• Destination: 1500 (the short code created above)
• Bearer: Any
3. To allow the video device on the S0 port to make outgoing calls to the PRI lines also
requires a short code. For this example the following is used:
• Code: 91N;
• Number: N
• Feature: Dial
• Line Group: 95
Polycom Video module settings
The Polycom modules used in the previous example were the Viewstation 128,
Viewstation 256 and Viewstation MP.
The Polycom module must have software that supports 'Standard ETSI ISDN'
(European ISDN) and have its ISDN Switch Protocol setting set to 'Standard ETSI
Euro-ISDN'
The following were the settings used during testing:
Characteristics Admin/Software and Hardware/
Software
• Polycom View Station 512 MP
• NTSC UIS Interface
• View Station PVS 1419
• Software: 7.0.1
• Network Interface: S/T Interface
• ISDN Version: IEUS v18:a00320
Admin/General Setup Admin/Video Network/ISDN Video
Network
Example of BRI So8 module configuration
Implementing the Avaya B5800 Branch Gateway November 2011 235