User's Manual

Replacing a component with one of lower capacity
About this task
If you are replacing a component with one of the same type but with lower capacity, when
restarted the B5800 Branch Gateway system configuration must be edited to remove
redundant entries.
Procedure
1. Turn the B5800 Branch Gateway system off. See
System shutdown on page 219.
2. Remove the card or external expansion module.
Note:
The card slot or expansion port used as the replacement must be installed in the
same position.
3. Install the replacement using the appropriate procedure for the type of component.
See Base and trunk card installation on page 53 or Connecting external expansion
modules on page 64 for more information.
4. Restart the B5800 Branch Gateway system.
5. Use Manager to delete the trunks or extensions/users in the configuration that are
no longer supported by the replacement component.
Replacing a component with one of a different type
About this task
If you are replacing a component with one of a different type, you must perform two procedures;
one to permanently remove the component and then one to add the component.
Procedure
1. Remove the existing component. See Permanently removing a component on
page 225.
Note:
Be sure to reboot the system and edit the configuration after you remove the
component.
2. Install the new component. See Adding a new component on page 225.
Additional installation and system procedures
224 Implementing the Avaya B5800 Branch Gateway November 2011
Comments? [e-mail]