User's Manual

4. Enter your user name and password.
5. In the Reboot window, do one of the following:
• Select Immediate to reboot the system immediately.
• Select When Free to reboot the system when there are no calls in progress.
This selection can be combined with the Call Barring options.
• Select Timed and then specify a time in hours and minutes.
This reboots the system the same as When Free but first waits for a specific
time. After the specified time, the system waits for there to be no calls in
progress and then reboots. This selection can be combined with the Call
Barring options.
Note:
If the time is after midnight, the system's normal daily backup is canceled.
6. In the Call Barring section, select Incoming Calls and/or Outgoing Calls. These
settings are used when the reboot mode is When Free. They bar the sending or
receiving of any new calls.
7. Click OK.
About changing components
Except for memory cards, cards and external expansions modules must only be removed and
added to an B5800 Branch Gateway system when the system is turned off. See
Memory card
removal on page 270 and System shutdown on page 219 for more information.
Note that for extension ports, by default both an extension entry and a user entry are configured
in the system. Extension entries can be deleted without deleting the corresponding user entry.
This allows retention of the user settings and association of the user with a different extension
by changing that extension's Base Extension number to match the user's Extension ID.
In the following procedures, the term component refers to a card fitted into the control unit or
an external expansion module.
Replacing a component with one of the same type
About this task
If you are replacing a component with one of the same type and capacity, no configuration
changes are required.
Additional installation and system procedures
222 Implementing the Avaya B5800 Branch Gateway November 2011
Comments? [e-mail]