User's Manual

• The shutdown process takes up to a minute to complete. When shutdown, the CPU
LED and the base card LEDs 1 and 9 (if trunk daughter card fitted) will flash red rapidly.
The memory card LEDs are extinguished. Do not remove power from the system or
remove any of the memory cards until the system is in the this state.
• To restart a system when shutdown indefinitely, or to restart a system before the timed
restart, switch power to the system off and on again.
Shutting down the system using Manager
Procedure
1. Start Manager.
2. Select File > Advanced > System Shutdown.
The Select IP Office window appears.
3. Select the B5800 Branch Gateway system you want to shut down.
The System Shutdown Mode window appears.
4. Do one of the following:
• To shut down the system for an indefinite period of time, select Indefinite.
To restart the system you must switch the power off and then on.
• To shut down the system for a specific period of time, select Timed and then
specify the duration in hours and minutes.
The system will automatically reboot after the set time has elapsed.
5. Click OK.
Shutting down the system using the System Status application
Procedure
1. Start System Status and access the system status output.
2. In the navigation panel select System.
3. At the bottom of the screen select Shutdown System.
4. Select the time duration for the shutdown or indefinite.
Additional installation and system procedures
220 Implementing the Avaya B5800 Branch Gateway November 2011
Comments? [e-mail]