User's Manual

• PSTN_VM_NUM
This sets the number dialed when the Message button is pressed and the phone is in
survivable mode. For example, a DID number for the Modular Messaging system.
• RECOVERYREGISTERWAIT
This is the monitoring interval used by the phone when no available controller was
detected by a previous monitoring check. The phone waits for a response from each
controller in the SIP_CONTROLLER_LIST with the
CONTROLLER_SEARCH_INTERVAL setting. The actual interval used is between 50%
to 90% of the setting. Range 10 to 36000 seconds. Default 60 seconds.
• REGISTERWAIT
This is the monitoring interval used by the phone when it has a currently selected active
controller. The phone waits for a response from each controller in the
SIP_CONTROLLER_LIST with the CONTROLLER_SEARCH_INTERVAL setting.
Range 30 to 86400 second. Default 300 seconds.
• SIMULTANEOUS_REGISTRATIONS
If the SIPREGPROXYPOLICY is set to simultaneous, the extension can remain
registered with multiple available controllers, though only the highest priority controller is
set as the active controller. This must be set to match the number of available Avaya Aura
®
Session Managers.
• SIP_CONTROLLER_LIST
This setting should contain a priority ordered list of SIP servers that the phone should
use. Each entry should contain the server IP address, port and transport method (TCP
or UDP). The multiple entries should be separated by a comma.
• The list should contain the primary Avaya Aura
®
Session Manager as the first entry
then the B5800 Branch Gateway. If there is an additional Avaya Aura
®
Session
Manager being used for redundancy (see “SecondaryAvaya Aura
®
Session Manager
line configuration in
Avaya Aura Session Manager line redundancy on page 118) it
should be included before the B5800 Branch Gateway entry.
• The string below would set the phone's primary SIP controller to the Avaya Aura
®
Session Manager and the secondary controller to an B5800 Branch Gateway used
in the basic configuration example:
SET SIP_CONTROLLER_LIST 10.80.100.23:5060;transport=tls,
35.1.1.51:5060;transport=tcp
Warning:
If the port and transport are not specified for a controller, the default values of 5061
and TLS are used. Note that B5800 Branch Gateway currently only supports TCP
and or UDP.
• SIPDOMAIN
Extension administration
200 Implementing the Avaya B5800 Branch Gateway November 2011
Comments? [e-mail]