User's Manual

Session Manager tab field descriptions
Name Description
Line Number This value is automatically assigned by
B5800 Branch Gateway and should be
unique for each line added to the
configuration.
In Service The default setting is enabled. This option
can be used to manually take the Session
Manager line out of service. It does not reflect
or set the actual state of the line.
SM Domain Name This name should match a SIP domain
defined in the Session Manager system's
SIP Domains table. Unless there are reasons
to do otherwise, all the B5800 Branch
Gateway systems in the Avaya Aura
®
network can share the same domain.
Note:
See Viewing the SIP domains on
page 150 for a list of SIP domains defined
in Session Manager.
SM Address Enter the IP address of the Session Manager
that the line should use in the Avaya Aura
®
network. The same Session Manager should
be used for the matching Entity Link entry in
the Avaya Aura
®
configuration.
Inactivity timeout (seconds) The default setting is 0. Keep the default
setting to maintain a persistent connection
with Session Manager.
Outgoing Group ID The default setting is 99999. This value is not
changeable. However note the value as it is
used in B5800 Branch Gateway short codes
used to route calls to the Session Manager.
Prefix This field is blank by default. This prefix will
be added to any source number received
with incoming calls.
Max Calls The default setting is 10. This value sets the
number of simultaneous calls allowed
between B5800 Branch Gateway and
Session Manager using this connection.
Each call uses one of the available licenses
that are shared by all SIP trunks configured
in the system.
Administering a Session Manager line for each branch
Implementing the Avaya B5800 Branch Gateway November 2011 115