User's Manual

3. If required, secure the extension arm fitting.
Use the
Allen key attached to the extender arm to secure the extension arm fitting
Allen screw.
4. Mount the extension arm on the tripod.
Place the brass end of the extension arm into the fitting, so that the keying hole of
the extension arm mates with the retaining thump screw locking device of the tripod
fitting. The thumb screw locking device clicks into the keying hole of the extension
arm.
5. Position the extension arm.
Orient the arm into the proper position. Secure the tripod fitting and the extension
arm thumb screw.
6. Affix the basestation to the extension arm.
Remove the basestation from the yellow case. Mount the basestation onto the end
of the arm. Screw the brass thumb screw on the arm into the bottom of the
basestation and secure it in place with the grey lock thumb screw.
7. Position the antenna.
Rotate the antenna from its stowed position, against the body of the basestation, to
its upright operating position.
8. Position the basestation. The normal position is with the antenna pointing
upwards.
Secure the basestation with the arm thumb screw.
9. Mount the battery fixture on the tripod.
Remove the battery bracket, shown in
Figure 53: Deployment tool battery details on
page 82
, from the yellow case. Screw the battery bracket onto the tripod caster
brace, with the two machine screws.
10. Mount the battery.
Pull the release pin on the bracket back and slide the battery grooves on to the
bracket. Ensure the bracket pin locks into the battery.
11. Connect the basestation to the battery.
Plug the basestation power cord connector into the upper right edge of the
battery.
Deployment tool
DMC DECT Fundamentals August 2012 83