User's Manual

Chapter 9: Adding a DMC8 to a non-SNMP
DECT system
It is possible to add DMC8 cards to a DECT
system that previously contained only DMC4 cards. The
system becomes an SNMP system. Therefore, DMC DECT Manager is used for management.
Note:
If the DMC8 is not new, ensure that the card has no subscriptions, or PARI/SARI, and has a known IP
address. (Default IP address is 192.168.1.1.)
Note:
A
vaya recommends that you avoid having the relay card (DMC8) as the lowest card in the system.
Additional DMC8 cards can be positioned in lower slots.
Important:
It is very important that all the DMC4 cards in the system have the latest non-SNMP
firmware
(45000405) before adding a DMC8 to a non-SNMP DECT system.
Adding a DMC8
1.
Connect the DMC8 to the DMC DECT Manager.
Caution:
Do not connect the faceplate connectors between the DMC4 and DMC8 at this
time.
2.
Create a new DECT system.
Use the DMC DECT Manager standard procedure to create a new DECT system.
Note:
The DMC8 is the only board visible on DMC DECT
Manager at this time.
DMC DECT Fundamentals August 2012 325