User's Manual

Changing an existing DECT system on DMC DECT Manager from
an Ethernet connection to a modem connection
It is possible to manage a DECT
system, which was previously managed using an Ethernet
connection, using modems.
To change an Ethernet connection to a modem connection, you must first install the modem
(see
Cable setup on page 315 and DECT relay board to remote modem on page 316
), and
complete all the steps in
Configuring NetBEUI Protocol on page 317.
Then complete the steps
in
Changing an Ethernet connection to a modem connection on page 323.
Note:
When connecting to the DECT relay board using modems, jumpers J6, J7, J8, and J9 must
be strapped for V.24 on the DMC.
Complete the following steps to change an Ethernet connection to a modem connection:
Changing an Ethernet connection to a modem connection
1. Select the DECT system that you want to change from an Ethernet connection to a
modem connection.
Open the DMC DECT Manager System window, and select the DECT system to be
changed.
2. Select File > Properties.
Select File on the toolbar, and select Properties from the File menu. The Properties
window opens.
3. Click the Communication tab.
4. Select the Serial radio button.
5. Click the Details button.
6. Enter the DMC DECT Manager Server IP Interface.
This is the IP address entered as the Client IP address in Configuring connection
properties on page
319, Step 15.
7. Choose the COM port to which the local modem is connected.
8. Enter the Phone Number of the remote modem.
9. Click OK.
10. Enter values in the Access Right Identification and Parameters tabs according to
normal operating procedures.
11. Click the Alarm tab.
12. Enter the DMC DECT Manager Server IP Interface IP address in the Upstream
Manager IP addresstext box.
Connecting a DECT system to DMC DECT Manager using remote modems and Windows 2000
DMC DECT Fundamentals August 2012 323