User's Manual

Figure 218: Local modem connected using Hyper Terminal
Use the initialisation commands in Table 53: Initialisation commands on page 321 to configure
the modems.
T
able 53: Initialisation commands
Initialisation commands Meaning
US Robotics:
AT
AT&F Set to factory default
AT&W0 Write setting into non-volatile memory 0
ATY0 At power up, start modem with settings
in non-volatile memory 0
Dynalink modem:
AT
AT&F Set to factory default
AT&K0 Flow control disabled
AT&W0 Write setting into non-volatile memory 0
ATY0 At power up, start modem with settings
in non-volatile memory 0
Adding a new DECT system to DMC DECT Manager
Before adding the DECT
system to DMC DECT Manager, the DECT relay card must be added
to the network.
Connecting a DECT system to DMC DECT Manager using remote modems and Windows 2000
DMC DECT Fundamentals August 2012 321