User's Manual

Modem setup
Install the local modem on the PC, then configure the modem.
Modem requirements
The modem requirements are:
•
56 Kbits/s
• Baud rate 38 400 Kbits/s fixed.
When using a US Robotics modem, use factory defaults.
Connect the modem to the required COM port on the PC using a standard DB-25 to DB-9
cable.
Configuring the local modem
1. Click the Start button on the PC taskbar.
2. Select Settings.
3. Select Control panel.
4. Double-click Phone and Modems Options.
5. Click the Modems tab.
6. Click the Add button.
7. Follow the Wizard.
Setting the modems to factory defaults
Connect to the local modem using Hyper
Terminal. See
Figure 218: Local modem connected
using Hyper Terminal on page 321. Set the remote modem to the factory defaults.
Changing the DMC8 jumper setting after DECT system upgrade to Release 5.0
320 DMC DECT Fundamentals August 2012
Comments? [e-mail]