User's Manual

If the NetBEUI Interface Service is already installed, it appears in the Local Area
Connection Properties dialog box (see Figure 217: Networking tab of the Local Area
Connection Properties on page 317).
If NetBEUI Protocol does not appear in the Local Area Connection Properties dialog
box, continue with Steps 3 – 6.
3. Click the Install button.
4. Open the Select Network Protocol dialog box.
Select Protocol in the Select Network Component Type dialog box, and click Add.
5. Add NetBEUI Protocol.
Select NetBEUI Protocol, and click OK.
The PC must be rebooted after installing NetBEUI Protocol.
Configuring a dial-up network on the DMC DECT Manager server
Complete the steps in Configuring a dial-up network on page 318 to configure a dial-up
network:
Configuring a dial-up network
1. Click the Start button on the PC taskbar.
2. Select Settings.
3. Select Control Panel.
4. Double-click Network and Dial-up Connections.
5. Double-click Make New Connection.
6. Click Next.
7. Select the network connection type.
Select the Connect directly to another computer radio button, and click Next.
8. Identify your computer as a Guest machine.
Select the Guest radio button, and click Next.
9. Select the device to make the connection.
Select Communications Port (COM x) from the Select a device: drop-down list, and
click Next.
10. Identify the connection availability.
Select the For all users radio button, and click Next.
11. Identify the network connection.
Enter a name for this connection, and click Finish.
Changing the DMC8 jumper setting after DECT system upgrade to Release 5.0
318 DMC DECT Fundamentals August 2012
Comments? [e-mail]