User's Manual

Figure 192: Add a DMC8 card to the system
Complete the following steps.
Adding a DMC8 card to a DECT system
1. Connect the bypass cable.
Plug the bypass cable into the Maint port of the existing DMC8.
2. Insert the DMC8 card, with a terminating plug installed,into the top port.
Lever the card into the shelf backplane and latch the card locking devices.
3. Connect the bypass cable to the added DMC8 card.
Plug the bypass cable into the Maint port of the added DMC8 card.
4. Remove the terminating plug from the existing card.
Remove the terminating plug from the bottom port of the existing DMC8 card.
5. Connect the faceplate cable.
Insertthe faceplate cables into the bottom port of the existing DMC8 card and the
added DMC8 card.
6. Disconnect the bypass cable.
Remove the maintenance bypass cable from the Maint port of the existing DMC8
card and the added DMC8 card.
7. Add the DMC8 card to the database.
Use the procedure: Inserting a serviceable DMC8 card on page 278
.
System maintenance
280 DMC DECT Fundamentals August 2012
Comments? [e-mail]