User's Manual

Figure 180: Telnet 192.168.1.1
Complete the following steps.
Changing the IP
address on DECT system DMC8 Relay card
1. Open the Telnet dialog box.
Click Start on the Windows taskbar and choose Accessories > Telnet.
2. Enter username and password.
Type username dasuser and password dasuser.
3. When the connection prompt local appears, change the DMC8 Relay card
address.
Enter the following command:
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
xxx.xxx.xxx.xxx = new IP address of the DMC8 Relay card.
yyy.yyy.yyy.yyy = subnet mask, usually 255.255.255.0
zzz.zzz.zzz.zzz = IP address if this is the gateway for the network.
Note:
Set zzz.zzz.zzz.zzz to the IP
address of the DMC DECT Manager server Ethernet
interface. If there are two Ethernet interfaces on the DMC DECT Manager server,
set zzz.zzz.zzz.zzz to the IP address of the interface, which is on the same
network as the DMC8 Relay card.
System administration
256 DMC DECT Fundamentals August 2012
Comments? [e-mail]