User's Manual

1. Configure a phantom superloop using LD 97, if required.
2. Create the new DCS sets in LD 10.
3. Configure the RCFW data in LD 57 and LD 15 for handsets assigned as a visitor.
4. Use the DECT manager to configure sets on the DMC8.
5. Pre-subscribe the visiting handset one time at the MCDN node.
Note:
Subscription includes both overlay configuration and DECT Manager
configuration. For DECT Manager configuration.
Table 40: LD 10 - Add/Change DCS data block or data blocks.
Prompt Response Description
REQ: NEW NEW 1-255
CHG ECHG
NEW = Add a Digital Cordless Set
NEW X =
The generation of new DCS units stop when
the maximum Index of 509 is reached on a single
DMC8 or VTNs on the system run out or WRLS
Licence limits reached. All new DCS must be on the
same DMC8.
CHG = Allows the DCS configuration to change to
another DMC8. All new DCS must be on the same
DMC8.
ECHG = This command can change either the VSIT
response or the HMDN response.
TYPE: DCS Digital Cordless Set. Differentiates between analogue
sets and concentrated digital DECT handsets.
If TYPE=DCS, the system allocates the next available
VTN, and WRLS defaults to YES and WTYP defaults
to DECT. If package #350 is included, MWUN defaults
to 32.
CLS defaults to ERCA, allowing the Enhanced RCFW
feature.
TN Terminal Number
l s c u Format for Large System and CS 1000E system,
where l = loop, s = shelf, c = card, u = unit
The system provides the Virtual TN for the handset.
CDEN
(4D) Card Density. Only valid value for IPE is 4D. Normal
input is <CR>.
WRLS
YES WiReLess analogue Set – entry defaults to YES with
no user input; value cannot be CHG'ed.
WTYP
DECT Wireless TYPe – entry defaults to DECT with no user
input; value cannot be CHG'ed.
Implementing and operating MSMN
DMC DECT Fundamentals August 2012 225