User's Manual

Figure 148: Telnet to 192.168.1.1
Complete the following steps to reset the DMC4 relay card to the server IP
address.
Resetting the DMC4 relay card to the server IP address
1. Open the Telnet dialog box.
Click Start on the Windows taskbar and choose Accessories > Telnet.
2. Enter the username and password.
Username: dasuser Password: dasuser
3. Change the relay DMC4 card address when the connection prompt local appears.
Enter the following command:
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
xxx.xxx.xxx.xxx = new IP address of the DMC4 relay card
yyy.yyy.yyy.yyy = subnet mask (usually 255.255.255.0)
zzz.zzz.zzz.zzz = IP address if this is the gateway for the network.
Note:
Set zzz.zzz.zzz.zzz to the IP
address of the DMC DECT Manager server Ethernet
interface. If there are two Ethernet interfaces on the DMC DECT Manager server,
set zzz.zzz.zzz.zzz to the IP address of the interface that is on the same network
as the DMC4 relay card.
Launch the DMC DECT Manager back-end process
The back-end process must be visible to establish a connection. If the back-end is closed in
error
, DMC DECT Manager does not run.
Upgrade a DECT system to an SNMP-managed system
DMC DECT Fundamentals August 2012 215