User's Manual

Note:
When the OK button or Apply button is clicked at this point, the manager attempts
to connect to the DECT system to write the MIB2 system name.
6. If required, program an Upstream Manager.
Go to Adding the upstream manager IP address, if required on page 190.
7. If an Upstream Manager is not required.
Go to Synchronizing data with DECT on page 191.
Adding the upstream manager IP address, if required
Figure 122: System Properties - Alarm
Complete the following steps.
Adding the upstream IP
address, if required
1. Open the DECT System Properties dialog box.
Pull down File>Add.
2. Open the Alarm dialog box.
Installation and configuration
190 DMC DECT Fundamentals August 2012
Comments? [e-mail]