User's Manual

Setting the DECT system IP address to match the DMC8 Relay card
Figure 121: System Properties - Communication
Complete the following steps.
Setting the IP
address of the DMC8 Relay card in the manager
1. Open the Communications dialog box.
Click the Communications tab.
2. Enter the IP address.
Type the IP address that was entered in
Resetting the DMC8 Relay card default IP
address to the LAN IP address on page 185
.
3. If the communication link is Ethernet, select Ethernet.
Click the Ethernet radio button.
4. If the communication link is Serial, select Serial.
Click Serial radio button.
5. Accept the changes.
Click the OK button.
Adding DECT
DMC DECT Fundamentals August 2012 189