User's Manual

Type username dasuser and password dasuser.
3.
When the connection prompt local appears, change the DMC8 Relay card
address.
Enter the following command:
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
xxx.xxx.xxx.xxx = new IP address of the DMC8 Relay card.
yyy.yyy.yyy.yyy = subnet mask, usually 255.255.255.0
zzz.zzz.zzz.zzz = IP address if this is the gateway for the network.
Note:
zzz.zzz.zzz.zzz must be set to the IP address of the DMC DECT Manager server
Ethernet interface. If there are two Ethernet interfaces on the DMC DECT
Manager server, zzz.zzz.zzz.zzz must be set to the IP address of the interface
that is on the same network as the DMC8 Relay card.
Connecting the DMC8 Relay card to the DMC DECT Manager server
Figure 119: NTCW12DA Ethernet cable to DMC DECT Manager Server LAN connections
Complete the following steps.
Installation and configuration
186 DMC DECT Fundamentals August 2012
Comments? [e-mail]