User's Manual

Figure 87: Connecting and securing the board
5.
Snap the cover of the C4010E basestation to the rear side, to close the C4010E
basestation cabinet. Fasten the cabinet by mounting the two screws into the two
holes in the rear side of the cabinet.
6. Insert the cabinet key and turn right to open the outdoor isolated cabinet.
7. Remove the foam blocks from the cabinet.
8. Mount the swivel, and lead the incoming cable through it. Make sure that the cable
inlet is waterproof. Connect the incoming cable to the connection box that is
Installation and configuration
148 DMC DECT Fundamentals August 2012
Comments? [e-mail]