User's Manual

Figure 85: Foam cover installation
8.
Close and lock the cabinet.
Installing a C4010E basestation in external housing with an external antenna
1. Unpack the C4010E basestation.
2. Open the cabinet of the C4010E basestation.
To open the cabinet remove the two screws at the rear side of the cabinet. Then
separate the cover and the rear side from each other.
The cabinet is closed by four 'click' parts, two at each long side of the cabinet. If
necessary, use a small screwdriver to carefully open the click parts one-by-one.
3. Drill two holes (10 mm in diameter) in the rear side of the cabinet.
Figure 86: Hole placement
4. Connect the antenna cables to the connectors on the printed circuit board. Secure
the nuts with an SMA Torque Wrench.
Installing the external housing
DMC DECT Fundamentals August 2012 147