User's Manual

External housing base
station number
External housing connector
box in number
MDF connection
Basestation 7
4 T20
5 R20
6 T21
3 R21
Basestation 8
4 T22
5 R22
6 T23
3 R23
Installing the external housing
Consult the work order
, then perform the steps in this section as required.
The section provides the following procedures:
• Installing C4600 and C4010 basestations in the external housing
• Installing a C4010E basestation in external housing with an external antenna
• Mounting the cabinet
Installing C4600 and C4010 basestations in the external housing
1. Open the cabinet by inserting the cabinet key and turn right.
2. Remove the foam from the cabinet as far as is shown Figure 110
3. Mount the swivel, and lead the incoming cable through it. Make sure that the cable
inlet is waterproof. Connect the incoming cable to the connection box that is
delivered with the outdoor cabinet. Also connect the CAT5 cable that is inside the
outdoor cabinet to the connector box. See pictures below.
Installation and configuration
142 DMC DECT Fundamentals August 2012
Comments? [e-mail]