User's Manual

Figure 76: Basestation mounting details
Caution:
Equipment Damage
The following procedure requires the removal of the basestation cover
. The circuit board is
attached to the basestation cover. Do not damage the circuit board or bend the two antennas
on the bottom of the circuit board.
Installing the basestation in the external housing
1. Open the external housing cover.
Insert the external housing key and turn clockwise.
2. Remove the basestation mounting plate.
Unscrew the four nuts securing the plate and pull the plate from the cabinet.
3. Remove the basestation cover. See the preceding caution note.
Carefully pry one corner of the cover from the basestation, then the other corner.
4. Remove the basestation lower screw hole cover.
Push the screw hole cover out of the basestation.
5. Mount the basestation to the housing plate.
Affix with the screws as shown in
Figure 70: Basestation mounting details on
page
131.
6. Replace the basestation cover.
Snap the cover in place.
7. Connect the connecting box cable to the basestation.
Installing the basestation
DMC DECT Fundamentals August 2012 137