User's Manual

Figure 70: Basestation mounting details
T
able 34: Basestation mounting details key
a screw mounting slot
b screw and cable tie retaining washer hole
c cable tie grooves
Installing C4600, C4610, and C4610E basestation
1.
Locate the basestation mounting position.
2. Install the basestation mounting screw.
If required, drill the holes for a screw anchor and install the anchor.
3. Fasten the basestation on the wall or a building protrusion.
Hang the basestation on the screw or use cable ties to mount the basestation. Insert
the cable ties in the vertical or horizontal grooves on the back of the basestation.
Secure the cable ties to the basestation with the retaining washers and screws
provided. Fasten the cable ties to the building protrusion.
4. If installing the C4610E basestation, install the external antenna according to the
instructions provided by the manufacturer.
Installing the wiring to the MDF
Consult the work order and marked-up floor plan to determine the basestation to MDF
connections, then follow the steps in
Installing basestation wiring to the MDF on page
132.
Caution:
Service Interruption
Installing the basestation
DMC DECT Fundamentals August 2012 131