User's Manual

Single and multiple floor deployment 73
By deploying the site using this method, cell centers are distributed
throughout the site. If the site is deployed from one end to the other, cell
centers can be clustered at one end of the site.
Single-cell deployment
Always start with the single-cell technique regardless of the width between
the two critical points. Using this technique, you can find one cell center
that serves two critical points, as shown in Figure 43 "Single cell distance"
(page 73).
Figure 43
Single cell distance
Procedure 14
Single cell deployment
Step Action
1 Identify the initial critical points. Mark them on the floor plan with
a . Use different color pencils for each critical point.
2 Choose the first critical point at the edge of the coverage area
furthest away from the center of the coverage area. Place the
deployment tool at this critical point.
3 Establish a link. For more information, see “Deployment tool”
(page 52).
4 Measure the range into the coverage area in a few directions to
determine where a cell center can be located, and still remain
within range of the critical point. Observe the deployment tool
handset RSSI value while moving away from the basestation.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.