User's Manual

232 System maintenance
See “Export a system” (page 228).
2 Uninstall the DAP Controller.
See “DAP Controller software deinstallation” (page 230).
3 Install a new version of the DAP Controller.
See “DAP Controller” (page 130).
4 Import the system you exported.
See “Import a system” (page 229).
OR
Create a new system if required. See “Configuration of settings
using IP DECT Configurator” (page 136).
--End--
Troubleshooting
The Troubleshooting section provides settings you can check to resolve
some common configuration problems.
If DAP is not working
Prerequisites
1.
The signaling server, call server, and DAP Controller are configured
and connected to the Ethernet.
2.
The SIP DECT system is configured in the IP DECT Configurator.
If DAP is not working, ensure that the DCHP and TFTP servers are
configured and running.
If you use the MS Windows DHCP Server, ensure:
the scope is created
the IP address range is added
the scope options are configured
the scope is activated
MS Windows DHCP Server is running
If you use the MS Windows TFTP Server, ensure:
the check box next to Run TFTP Server on this PC is checked
Windows TFTP Server on this PC is selected
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.