User's Manual

230 System maintenance
DAP Controller deactivation
You can use the DAP Controller to configure the SIP DECT system. In
addition, as long as the DAP Controller is connected and active, it can
perform the following functions:
Process messaging (Low Rate Messaging and interaction with DECT
Messenger).
Move subscriptions from a DAP that is not working to working DAPs.
After a DAP is unavailable for 15 minutes, the system considers it to
be not working.
Monitor the SIP DECT system and send archives and alarms by email.
After you have configured the SIP DECT system using the DAP Controller,
you can perform either of the following:
Leave the DAP Controller PC connected and active, so that it performs
all the functions listed above, and you can use it at any time to
configure the SIP DECT system.
Deactivate the DAP Controller software. You can then use the DAP
Controller PC for other purposes, and if necessary you can disconnect
it from the network completely. You can reactivate the DAP Controller
software at any time to configure the SIP DECT system.
If you choose to disconnect your DAP controller PC from the network,
you must first complete the following procedure to deactivate SIP DECT
services.
Procedure 116
Deactivating SIP DECT services
Step Action
1 Launch DAP Configurator
2 In the IP DECT Configurator main window, click Activate/Deac
tivate/System Status.
3 Click Deactivate All to stop all enabled services and programs.
4 Once the system is deactivated, click Exit.
--End--
DAP Controller software deinstallation
If you need to remove the DAP Controller software, use the steps in the
following procedure.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.