User's Manual

126 Software requirements
12 Click Apply.
13 Start the DHCP server with Start > All Programs > DAP
controller.
14 Reboot the DAPs.
Note: If you are configuring a new system, follow the steps in
Procedure 51 “Configuring SIP Settings” (page 141) instead
of rebooting DAP
--End--
Built-in TFTP server
The DAP controller 4 comes with a built-in TFTP server that runs as a
service under Microsoft Windows. You can use the IP DECT Configurator
tool available under the DAP controller 4 to start or stop the TFTP server
program. You can start or stop the service through the services window in
Microsoft Windows.
Configuration without DHCP or TFTP
ATTENTION
DAP configuration without DHCP or TFTP requires DCHP and TFTP to be
temporarily available to program or reprogram DAPs.
You can perform DAP configuration without DHCP or TFTP only after you have
installed IP DECT Configurator. See “DAP Controller” (page 130) for details.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.