User's Manual

Important:
If the environment names for eTM_HA are not defined with a name containing the local IP
address, rename the registry structure generated by eGRID or eCONFIG, so that the IP
address is available in the name.
The eTM structure can contain one or multiple environments. If you launch the eTM_HA.exe
without additional parameters, the program analyzes the available environments of the registry,
and prompts for an initial environment at startup.
Figure 72: Example of two environments on page 69 shows an example, with two
environments defined. One environment is called Site 1 – Environment 10.110.50.138. The
other is called Site 1 – Environment 10.110050.138 (backup).
Figure 72: Example of two environments
If eTM_HA.exe is launched without additional parameters on a system with local IP address
10.110.50.138; then a prompt appears as follows:
"C:\SOPHO Messenger@Net\Exe\eTM_HA.exe"
Figure 73: Selecting an environment when more than one is defined
Note:
Because the objective of this module is to provide high availability, Avaya recommends that
you suppress this prompt. This can be accomplished by adding a parameter on the
command line of the shortcut specifying the initial environment to select. This is performed
by means of the optional keyword /Environment.
Create a shortcut for eTM_HA in the startup group specifying the initial environment, as follows:
"C:\SOPHO Messenger@Net\Exe\eTM_HA.exe" / Environment:Site 1 – Environment
10.110.50.138
Registry settings eTM
DECT Messenger Installation and Commissioning — Book 2 March 2012 69