User's Manual

Chapter 3: Module - eSNMP
Important:
Due to the ongoing development of the DECT Messenger product suite, some modules that provide
additional functionality may become available after the initial release of DECT Messenger 4.0.
The following modules are described in this document but are not available at initial General
Availability.
• eFR
• eLICENSE
• eLOCATION
• eSMS
• eSNMP
• eVBVOICE
The eFR module is an add-on module and is licensed separately through the eLICENSE module. Some
of the modules listed in this attention box are available only on a site-specific basis.
Architecture
The eSNMP module is able to receive SNMPv1 and SNMPv2 traps sent from an external
SNMP trap sender to DECT Messenger. The eSNMP module uses an SNMP trap receiver. As
a result of a received SNMP trap, an alarm is activated or deactivated on the Messenger
platform.
At startup, eSNMP contacts eKERNEL to request the configuration of eKERNEL. The IP
address and port of eSNMP is configured in the shortcut. When parameters are absent, the
startup values are prompted, as shown in the following figure.
DECT Messenger Installation and Commissioning — Book 2 March 2012 41