User's Manual

WUM_Message_str
This field specifies the message that is shown to the eWEB user in the Send User Message
functionality, and finally is sent to the destination users. Note the length of the message must
be smaller than or equal to the maximum length associated with the WUM_AlA_id_n definition
in eKERNEL_ALARM table. For authorized, when an alarm identifier defines maximum length
in eKERNEL_ALARM table of 48 bytes, the specified message must not be longer that 48
bytes. A special value *FREE can be defined, enabling the end user to enter a message.
An authorized of an entry typically found in this field is as follows: Evacuation (qualified) or
*FREE (user-defined message)
WUM_AlA_id_n
This field must have a value that corresponds with any of the definitions in ALARM table for
the eWEB interface. For authorized, if eWEB is input program 11701 and eKERNEL_ALARM
table contains alarm identifiers 1170101 and 1170102 and 1170103, one of these defined
values must be used. In most cases, a number of alarm identifiers are defined to handle
different message lengths and different message priorities.
An authorized of an entry typically found in this field is as follows: 1170101
WGM_Comments_str
This field can be used by an administrator to enter some remarks. The field is informational
only.
Table 57: eWEB_SNDUSRMSG sample data on page 382 shows authorizeds of data found
in the eWEB_SNDUSRMSG table.
Table 57: eWEB_SNDUSRMSG sample data
User Sequence Message Alarm id Comments
*ALL 1 Normal message 1 for *ALL 3170101
*ALL 2 Shared message 2 for *ALL 3170101
*ALL 3 Shared message 3 for *ALL 3170101
*ALL 4 Shared message 4 for *ALL 3170101
*ALL 5 Shared message 5 for *ALL 3170101
*ALL 6 Shared message 6 for *ALL 3170101
*ALL 7 *FREE 3170101
Table: eWEB_SNDUSRMSG
382 DECT Messenger Installation and Commissioning — Book 2 March 2012
Comments? [e-mail]