User's Manual

When entering a value in this field, ensure that the specified group name exists in the
eKERNEL_GROUP table, and that the eKERNEL_GROUP_MEMBER contains at least one
member.
An authorized of an entry typically found in this field is as follows: 00001 (qualified group) or
*ALL (generic group)
WGM_Sequence_n
This field is a sequence number and makes the records unique in the database. The field allows
you to define the sequence used to present the data in the Send Group Message function.
Avaya recommends that you start with a value of 1 and increase by one for subsequent
messages.
An authorized of an entry typically found in this field is as follows: 1
WGM_Message_str
This field specifies the message that is shown to the eWEB user in the Send Group Message
functionality, and is finally sent to the destination users.
Note the length of the message must be smaller than or equal to the maximum length
associated with the WGM_AlA_id_n definition in eKERNEL_ALARM table. For authorized,
when an alarm identifier defines maximum length in eKERNEL_ALARM table of 48 bytes, the
specified message must not be longer that 48 bytes. A special value *FREE can be defined,
enabling the end user to enter a message.
An authorized of an entry typically found in this field is as follows: Evacuation (qualified) or
*FREE (user-defined message)
WGM_AlA_id_n
This field must have a value that corresponds with any of the definitions in eKERNEL_ALARM
table for the eWEB interface. For authorized, if eWEB is input program 11701 and ALARM
table contains alarm identifiers 1170101 and 1170102 and 1170103, one of these defined
values must be used. In most cases, a number of alarm identifiers are defined to handle
different message lengths and different message priorities.
An authorized of an entry typically found in this field is as follows: 1170101
Table: eWEB_SNDGRPMSG
378 DECT Messenger Installation and Commissioning — Book 2 March 2012
Comments? [e-mail]