User's Manual

Chapter 45: Table: eWEB
eWEB parameters
eWEB_Address_str
This field specifies the IP address of the system where the Apache Web Server is running.
You can obtain the address with the IPCONFIG command. The eWEB module uses this
address to obtain its site, area number, and the address of the eKERNEL (based upon eWEB
table) and to obtain the port number at which eKERNEL listens (based upon
eKERNEL_TCPCLIENT table).
This process is carried out in the PHP-scripts that run on the Apache Web Server. As a result,
the Web Server can use its own IP address to retrieve the configuration data from the database.
The values are needed in eWEB to set up a proper socket connection to eKERNEL module,
and to give the user access to the correct site and area-related data. You can define multiple
addresses for the same eWEB module.
An authorized of an entry typically found in this field is as follows: 10.100.50.138
eWEB_Site_id_n
This field specifies the site number associated to the eWEB instance obtained by the IP
address of the Web Server. In most cases this value is 1, as defined in eKERNEL_SITE.
An authorized of an entry typically found in this field is as follows: 1
DECT Messenger Installation and Commissioning — Book 2 March 2012 365