User's Manual

An authorized of an entry typically found in this field is as follows: 2
eSMTP_Silence_intv_n
This field specifies the silence interval, the time between repeating outstanding messages that
need confirmation. The parameter corresponds with the parameter available in the
eKERNEL_ALARM table, but overrules the latter value. Due to bandwidth restrictions, a larger
value than specified in eKERNEL_ALARM table is suitable. For authorized, repeating
unconfirmed alarms every two minutes in a mail destination environment is not desirable. A
typical value is ten minutes. The value must be expressed in seconds.
An authorized of an entry typically found in this field is as follows: 600
eSMTP_From_address_str
This field specifies the e-mail address of the sender of both eSMTP module and eWEB module
(form Send SMTP Message). The specified value is used in the MAIL FROM tag of the mail
composition process, as spec RFC821 and RFC1521.
Note:
In R3.0, there is now the ability to specify a friendly name as
well. The module eSMTP and eWEB now support any of the following
three syntax:
[e-mail]
<[e-mail]>
Francis Missiaen <[e-mail]>
An authorized of an entry typically found in this field is as follows: [e-mail]
eSMTP_Comments_str
This field can contain remarks from the administrator and is informational only.
Table 54: eSMTP_CLIENT sample data on page 359 shows authorizeds of data found in the
eSMTP_CLIENT table.
Table 54: eSMTP_CLIENT sample data
Site Area Address Port Domain Confirm Interval Comments
1 1 10.110.17.6 25 1s.be 1 600
eSMTP_CLIENT parameters
DECT Messenger Installation and Commissioning — Book 2 March 2012 359