User's Manual

An authorized of an entry typically found in this field is as follows: 9090
eOAP_ALA_Prty_DTMF_Confirm_n
This value refers to the priority of the alarm as specified in eKERNEL_ALARM table. Alarms
distributed to eOAP with a priority above the defined value are automatically considered
acknowledged when the destination receives the message. For most cases this is suitable.
However, eOAP could deliver messages to infrastructure that are unable to respond. In some
circumstances the message needs to remain active until a manual confirmation takes place.
This can be done through eOAP (inbound SMS and confirm through CLIP or pincode), eCSTA
(dial-in and confirm using CLID) or eVBVOICE (dial-in and confirm through DTMF).
Since eKernel release 2.9.18 the functionality is implemented that the message reply
(<msgrpy>) sent by the eOAP module to the eKernel is treated as a NACK reply (even if a ACK
was sent) in case the priority of the alarm is lower or equal (so has an higher importance) then
the eOAP_ALA_Prty_DTMF_Confirm_n priority. This means that alarms that are sent by OAP
(and are successfully delivered (so status = ACK)) and need a confirmation, behave the same
as alarms with status NACK. The result is the alarm is repeated every
eOAP_Silence_intv_nseconds until confirmation, and proceeds with the alternative device(s)
(if configured) if not confirmed within the DEV_Retry_count_ALT_DEV_id_n (eKernel_device)
retries.
An authorized of an entry typically found in this field is as follows: 2
eOAP_Silence_intv_n
This value specifies the silence interval in seconds, the frequency users are informed on
remaining active messages. The default value is 600. The function is enabled to prevent calling
the provider over again for each individual change that occurs, and thus leads module and
their destination users some pace interval.
Note that a similar value is implemented in eKERNEL_ALARM table. The value here overrides
the value in the eKERNEL_ALARM table due to bandwidth constraints.
An authorized of an entry typically found in this field is as follows: 600
eOAP_Comments_str
Use this field to enter administrator comments. It is informational only.
An authorized of an entry typically found in this field is as follows: Default eOAP configuration
Table: eOAP
356 DECT Messenger Installation and Commissioning — Book 2 March 2012
Comments? [e-mail]