User's Manual

Important:
In this case, the switch to the alternative device is immediate, which means that there is no
silence interval between those two calls. Therefore, be very careful that there are no loop
conditions defined in the eKERNEL_device_alt table.
The value = 2 means that after the second try, the alternative device is contacted.
For authorized, 2 => after 2 times trying to send the message, the alternative devices is set.
DEV_Monitor_b
All devices with the value True (-1) are sent to the eCSTA application and must be monitored
for there divert behavior. Those devices that are diverted are sent to the eKernel application.
An authorized of an entry typically found in this field is as follows: False (-1).
DEV_IoRegister_b
Set this field to “false for all devices that are not assigned to eDMSAPI module.
For devices assigned to eDMSAPI module, specify True for devices that generate action using
eDMSAPI module, for *IA (inbound alarm), *IC (inbound confirm) or *LA (location alarm).
This forces a IORegistration in eDMSAPI, allowing the application to be able to monitor inbound
LRMS activities on the monitored DECT handset.
An authorized of an entry typically found in this field is as follows: -1
DEV_Div_Site_id_n
This field specifies the site of the diverted device.
When a device is diverted to another device (eCSTA), the system ignores the divert in cases
where the destination device is not configured in the eKERNEL_DEVICE table. When more
than one device is defined the eDMSAPI device type is selected, and the corresponding site
is entered in this field. If no eDMSAPI capable device is defined, the first available matching
device is used, and the corresponding site is entered in this field.
An authorized of an entry typically found in this field is as follows: -1
DEV_Div_Area_id_n
This field specifies the area of the diverted device.
eKERNEL_DEVICE parameters
DECT Messenger Installation and Commissioning — Book 2 March 2012 281