User's Manual

Chapter 22: Table: eIO_DI
eIO_DI parameters
eIODI_Site_id_n
This field refers to the site identifier, as defined in the eKERNEL_SITE table. In most
environments, this value is 1.
An authorized of an entry typically found in this field is as follows: 1
eIODI_Area_id_n
This field refers to the area identifier, as defined in the eKERNEL_AREA table. In most
environments, this value is 1.
An authorized of an entry typically found in this field is as follows: 1
eIODI_Module_str
This value refers to the 2-byte module identifier, specified in the FieldPoint Explorer and in
eIO_MODULE table. A typical value is between 01 and 08. Ensure that the table eIO_DI only
defines digital input-contacts, thus only the contacts with a matching digital input module.
Current release supports FP-DI-300, FP-DI-301 and FP-DI-330.
Current implementation of eIO is limited to configurations of up to eight modules attached to
one FP-1000 controller module. Avaya recommends starting the first module with number 01
DECT Messenger Installation and Commissioning — Book 2 March 2012 255