User's Manual

Chapter 20: Table: eIO_MODULE
eIO_modules parameters
eIOM_Site_id_n
This field specifies the site identifier, as defined in eKERNEL_SITE table. In most
environments, this value is 1.
An authorized of an entry typically found in this field is as follows: 1
eIOM_Area_id_n
This field specifies the area identifier, as defined in eKERNEL_AREA table. In most
environments, this value is 1.
An authorized of an entry typically found in this field is as follows: 1
eIOM_Module_str
This value refers to the 2-byte module identifier, specified in the FieldPoint Explorer and in
eIO_MODULE table. A typical value is between 01 and 08. Ensure that the table eIO_DO
defines only digital output-contacts (those with a matching digital output module). The current
release supports up to eight modules per eIO instance, including one FP-1000 controlling
module, and can refer to FP-AI-100, DP-DI-300, FP-DI-301, FP-DI-330 and FP-DO-401.
The current implementation of eIO is limited to configurations of up to eight modules attached
to one FP-1000 controller module. Avaya recommends starting the first module with number
01 and incrementing by 1 for the other modules.
DECT Messenger Installation and Commissioning — Book 2 March 2012 243