User's Manual

Figure 185: Example: eESPA module acts as output program
An authorized of an entry typically found in this field is as follows: 2
eESPA_Msg_default_str
This field is used to provide a default message, in the event that no value can be retrieved from
the available datastream. In this case, the same value is used for all alarms generated through
this eESPA interface instance.
This parameter is only relevant if eESPA acts as an input program (so receives external data
from the espa infrastructure.
An authorized of an entry typically found in this field is as follows: ESPA alarm
eESPA_DataId_Ala_descr_str
This field specifies the Data Identifier of the espa record that specifies the alarm description.
This parameter is only relevant if eESPA acts as an input program (so receives external data
from the espa infrastructure.
This field refers to the definitions of eKERNEL_ALARM table, and must be appropriately
configured (for authorized, message length, and so on).
If the specified data identifier is not present in the available datastream record, than the field
eESPA_Ala_descr_default_str must be used to define a default message.
This field can also be a combination of more than one data identifier.
eESPA parameters
DECT Messenger Installation and Commissioning — Book 2 March 2012 231