User's Manual

US Unit separator
RS Record separator
BCC Checksum
The incoming alarm/message, must be translated to a valid message request and sent to the
eKERNEL, as shown in Figure 182: Example: eESPA module acts as input program on
page 228.
Figure 182: Example: eESPA module acts as input program
If the specified data identifier is not present in the available datastream record, than the field
eESPA_Group_default_str must be used to define a group in the message request.
If this eESPA module acts as an output program:
In the current release, the data identifiers for the espa records are fixed. Therefore, when a
message request is sent by the eKERNEL to the eESPA module, the data in the <group> tag
is put in data identifier 1 (call address).
In the following authorized, the data in the <group> tag from the message request, must be
translated to data identifier 1 (call address) in the espa record.
Table: eESPA
228 DECT Messenger Installation and Commissioning — Book 2 March 2012
Comments? [e-mail]