User's Manual

Refer to the sample data in Table 14: Sample Data on page 223 for authorizeds of message
definitions. As illustrated in the authorizeds in Table 14: Sample Data on page 223, messages
are built based upon fixed characters, plus the following:
• [Calling number]
• [Called number]
• [msg] special value
• some combination of the three preceding values that are replaced by the actual value of
the request
A format REA [Calling number] translates into REA 865 when the calling number is 865.
In release 3.0 and later, you can use a visual DNR to a device in the Messenger (new field
DEV_Visual_dnr_str in table eKERNEL_DEVICE). Now when the system configuration
configures a device with a visual DNR, this DNR is used to format a message when the
message contains [Calling number]. The end user is confronted with the visual DNR instead
of the device id.
An authorized of an entry typically found in this field is as follows: (see Table 14: Sample
Data on page 223)
eDMSAPIIR_Descr_str
This field is informational only.
eDMSAPIIR_Comments_str
This field is used by administrators to add some remarks. The value is informational only.
Table 14: Sample Data
Site Area Called
device
Calling
device
Group Message
1 1 222 8* E2TESTG
RP
TEST : [msg] from [Calling
number] to [Called
number].
1 1 56789 86* E2TESTG
RP
TEST 86* [msg]
1 1 56789 861 E2TESTG
RP
TEST 861 [msg]
1 1 56789 865 E2TESTG
RP
TEST 865 [msg]
eDMSAPI _inbound_result parameters
DECT Messenger Installation and Commissioning — Book 2 March 2012 223