User's Manual

eDMSAPI_Msg_dly_n
This field specifies the delay in seconds between sending the individual requests: send normal
message and send urgent message.
An example of an entry typically found in this field is as follows: 3
eDMSAPI_GeneralTimeOut_n
This field specifies the Time, in seconds, the eDMSAPI program waits for an event from the
CSTA service. This value is by default 10 seconds, and must be greater than 5.
When no event is received within this time, a negative acknowledge is sent to the eKERNEL
application or External clients for outbound calls.
An example of an entry typically found in this field is as follows: 10
eDMSAPI_Ack2TimeOut_n
Time in seconds the eDMSAPI program waits for an ACK message request from the iSPBS,
signaling that an URGENT message has been read by the DECT user (outbound calls).
An example of an entry typically found in this field is as follows: 30
eDMSAPI_DataPathDelay_n
This keyword specifies the time in seconds to wait between receiving a StopDataResult event
form a device and before sending a new StartDataPathRequest for the same device.
The default value is 2 seconds.
This parameter is implemented because the eDMSAPI module receives Universal failure
events (reason = INVALID_CALLING_DEVICE) when sending a StartDataPathRequest
directly after receiving a StopDataResult for the same device.
An example of an entry typically found in this field is as follows: 2
eDMSAPI_Comments_str
This field contains remarks from the administrator and is informational only.
Table: eDMSAPI
212 DECT Messenger Installation and Commissioning — Book 2 March 2012
Comments? [e-mail]