User's Manual

For example, if 1 is specified, alarms with alarm priority of 1 are handled as emergency
messages, whereas alarms with priority of 2, 3, 4, and so on are handled as urgent or normal
messages. Avaya recommends that you carefully evaluate the consequences of changes to
this field, for two reasons:
• Emergency messages impact the DECT C4060 user (different tone, user intervention
required for acknowledge).
• Emergency messages impact throughput, because normal message allocates a datapath
a few seconds, while urgent messages can allocate more than 30 seconds, depending
on the timeout value specified for user confirmation.
An example of an entry typically found in this field is as follows: 1
eDMSAPI_api_address_str
This field specifies the IP address of the CSTA Service.exe module. In most cases this is the
same value as the local IP address of eKERNEL, and can be obtained with IPCONFIG.exe.
An example of an entry typically found in this field is as follows: 10.110.50.138
eDMSAPI _API_port_str
This field specifies the port to which CSTA Service.exe listens, and (in the current release)
must always be set to 59000.
An example of an entry typically found in this field is as follows: 59000
eDMSAPI _PBX_address_str
This field specifies the IP address of the PBX. The information is distributed to CSTA
Service.exe, which handles the sockets connection between DECT Messengerand the PBX.
Contact the switch administrator to obtain the IP address of the switch. If a different addressing
scheme or subnet mask is in use, appropriate TCP/IP network configuration must be performed
on both platforms (default gateway, additional interface, and so on).
An example of an entry typically found in this field is as follows: 10.110.49.171
eDMSAPI_PBX_port_str
This field specifies the port to which the PBX listens, and depends on the PBX type. In previous
releases, the recommended value was 2555, which is the default port to which a SOPHO DMC
listens. Starting from R3.0, there is also support for DAP controller and Avaya. The
recommended default value for DMC is still 2555, and the recommended default value for DAP
Table: eDMSAPI
210 DECT Messenger Installation and Commissioning — Book 2 March 2012
Comments? [e-mail]