User's Manual
Figure 27: eDMSAPI module details window
4. Select and modify PBX type to indicate the type of device the module connects to
(iS3000, Avaya or DAP Controller).
5. Select and modify PBX address to match the IP address of your target device.
6. Select and modify PBX port to match the port number of your target device.
7. Select and modify the Seats count according to the number of seat licenses
available in your PBX.
Note:
Ensure that the seat count number plus the seats required by module eCSTA is
equal or lower than the maximum number of seats licensed on the target PBX.
Otherwise, you will not be able to make a LRMS message call.
8. Click OK to save the changes.
Adding a device
You require devices to output alarm messages notifications received from input modules. The
following procedure describes how to add a device for sending alarm messages to DECT
handsets. You can repeat the same procedure for other device types. You can also modify the
sample devices installed by default with the product.
Configuring DECT Messenger
DECT Messenger Installation and Commissioning — Book 1 March 2012 57