User's Manual
[DAPPRF] ; Start of DAPPRF address section
192.168.17.74
[CDA] ; Start of CDA address section
192.168.17.74 30160
[GK] ; Start gatekeeper address section
192.168.17.200 5060
[XDS] ; Start SIP section
b2b_ua=yes
[CONFIG] ; Start of static config section
CONFIGFILE=replace
IPCONFIG=replace
The TCP/IP port for Messaging is located in the [DS] section. The IP address of the DAP
Controller PC is followed by a port number range.
The port for LRMS messaging is the first port number plus 1. In the above example, the LRMS
port on the DAP Controller is port 28001. This is the port number that must be entered in the
DECT Messenger eDMSAPI module along with the DAP Controller IP address.
The port number for Location Detection is the first port number plus 8. In the above example,
the Location Detection port on the DAP Controller is port 28008. This is the port number that
must be entered in the DECT Messenger eLOCATION along with the DAP Controller IP
address.
National Instruments Analog/Digital Hardware
To use Digital Input/Output and Analogue Input functionality in message processing, DECT
Messenger requires National Instruments FieldPoint (FP) hardware modules.
Figure 3: National Instruments FieldPoint hardware modules
DECT Messenger supports the following types of IO modules:
• Control modules
• I/O modules
The following tables provide an overview of these modules.
National Instruments Analog/Digital Hardware
DECT Messenger Installation and Commissioning — Book 1 March 2012 19