User's Manual

value is usually specified, because eKERNEL and eIO both share the same network
adapter. When eIO is running on a different computer, the IP address of the eKERNEL
must be specified.
• eKernel port
Refers to the port number eKERNEL listens to for that specific eIO instance. This port is
defined in the eKERNEL_TCPCLIENT table.
• Log drive
Specifies the drive letter where logging files must be stored.
When all parameters are correctly specified, the eIO contacts the eKERNEL application,
producing the log information shown in
Figure 128: Logging information for eIO on
page 180.
Figure 128: Logging information for eIO
Once connected to eKERNEL, the eIO module requests its configuration. This is performed
through a configuration request. The eKERNEL fetches the configuration from the
IO_MODULE, eIO_AI, eIO_DI and eIO_DO tables and responds with all relevant parameters
that are needed for eIO to continue processing.
Figure 129: eIO configuration request and
response on page 181 shows the configuration request and the response eKERNEL sends
back.
Module - eIO
180 DECT Messenger Installation and Commissioning — Book 1 March 2012
Comments? infodev@avaya.com